|
|
Configuration used: Clampex V8 and a Digidata 1320 Driving the RSC-100, -160 & -200 can be done using one of the analog output of the Axon Digidata. The first thing to do is to configure the chosen analog output (e.g. DAC1): go to the menu {Configure - LabBench} Then... Select {Output Signals}{analog OUT#1}{Cmd1} Enter a Signal unit (e.g. tube#)Enter 10 as the scale factor (10 tubes/V <=> 100 mV per tube)
Connect the "analog OUT#1" of the Digidata to the "analog in" of the RSC. Once this is done, the RSC can be controlled manually using the Real-Time Control Panel (RTC) of Clampex...
... or automatically using the Clampex protocol: see to the left a sequence used to change tube number every episode ...
see to the left a sequence used to change tube number within the same episode ...
Return to the RSC page |
